view all articles
Water Pump Cavitation and Solutions

Water Pump Cavitation Solutions

Cavitation is the formation of vapor bubbles in the cooling system and their subsequent implosion. Vapor bubbles form in coolant when the coolant temperature increases, coolant pressure drops or a combination of a decrease in pressure combines with an increase in temperature.

Water pump cavitation is limited, for the most part, to high-rpm engines. Many late-model vehicles are installing small, cubic inch, four-cylinder engines with turbo chargers. By design, these engines rotate at much higher rpm than larger cubic inch engines. Most engines over 3-liters have rpm limits in the range of 5,500.
The turbo charged engines may turn upward of 7,000 to 8,000 rpm. This is where water pump cavitation becomes a factor.

Water Pump Cavitation

Water pump cavitation occurs at very high rpm. Most small cubic inch engines use a water pump pulley that produces an overdrive situation. If the engine is turning 7,000 rpm, the water pump is turning approximately 8,600 rpm. At this rate of rpm, it can actually create a low pressure situation on the inlet side of the pump. Even with an 18-lb. radiator cap and a 195-degree thermostat, the pressure can drop to 0.

In this situation, the lack of pressure causes the coolant to boil instantly and turn to steam. When this happens, the automotive water pump will not move steam at all. The steam pocket prevents all movement of coolant through the system. The area of 0 pressure will not absorb heat due to the lack of coolant. The area adjacent to the steam pocket will begin to overheat immediately.
Lowering the rpm is the only course of action to keep the engine from overheating.

There is another possible cause for water pump cavitation. If the radiator is restricted, a radiator hose is crimped, collapsed or in any way restricting the water flow to the pump, it will have the same effect. The coolant flow to the pump will be insufficient to keep up with the increase in demand at high rpm, causing a low-pressure area at the inlet side of the pump.

Solutions to Water Pump Cavitation

Over the years, manufacturers have employed several methods to reduce cavitation. Coolants have been developed that resist the formation of vapor bubbles and protect surfaces from cavitation damage. Advances have been made in pressurized cooling systems and reducing cooling system pressure changes. Also, raw materials now better tolerate cavitation and water pump impellers that reduce the formation of bubbles are now common.

Here are a few ways to keep cavitation problems to a minimum:

  • Use manufacturer-recommended antifreeze
  • Repair ALL cooling system leaks – even minor ones
  • Regularly test the pressure cap
  • Replace faulty parts with quality products (ie. Water pump, thermostat, pressure caps)
  • Avoid modifications

Given all of this information, it is important to note that faulty pressure caps and coolant that is of the wrong type, diluted or contaminated are more likely to cause water pump cavitation than the pump itself. Therefore, a full cooling system inspection is recommended when any cooling system issues arise.

Signup For Our Newsletter!

Get Updates on all of our latest content, news, and training.

Cancel
Submit